nuzmur

Currently the following devices officially support DIY: - Basic R3 - RF R3 - Mini As DIY is enabled by connecting GPIO16 to GND it may well be possible that other devices running eWelink will support it. Note The OTA process provides through the DIY procedure does not create a backup of the Itead firmware on the device. If you use this OTA method to flash Tasmota on the device, you will not be able to revert to the original factory firmware.

DIY Software 1.2 update:
1. Specify the description of how to enter the DIY MODE;
2. Add the guide of LED blinking in DIY MODE and failure diagnosis;
3. Solutions to clean the user setting in DIY MODE;
4. LAN requirement (2.4GHz with mDNS service supported) for DIY MODE device connection;
5. Test environment set up process via tool_01DIY85(3.3.0).exe;
6. Specify each API information further and add a new API control of " Get Device info" in real time;

How to use ?
Pair the device with the eWeLink app and update firmware. The wifi network you connect to during this step will need to be reachable in order to enter DIY mode. Follow instructions how to enter DIY mode from Sonoff. This is the excerpt from it: Long press the button for 5 seconds to enter pairing mode, then press another 5 seconds to ender Compatible Pairing Mode (AP). The LED indicator should blink continuously. From mobile phone or PC WiFi setting, an Access Point of the device named ITEAD-XXXXXXXX will be found, connect it with default password 12345678